The Secrets of Correctly Stringing Your Guitar
This weeks article is about one of the more mundane tasks you face as a guitarist., stringing the guitar. When I first started to learn the guitar this, along with tuning the damn thing, took me the longest to master. Ok, so you can take it along to the local guitar shop or get your guitar hero buddy to sort it out for you but the sooner you can do it yourself the better. You'll probably find yourself needing to change your strings at least every fortnight so this will be a common task for you and knowing how to do it well will make your guitar sound and play better so enjoy the article and have a go at stringing your guitar next time.
Gary Moyle (Founder of www.learntheguitarnow.com)
Why do you care about stringing your guitar you may ask. Well the reason is simple. It will make you sound better because if your guitar is properly strung, you will get longer natural sustain.
This is something that no fx pedal can reproduce, clean natural sustain. Of course after you have this sustain you can play with it all you want with your fx pedals.
Many guitarist make the same mistake when stringing a guitar, they don't wind enough of the string onto the tuning peg or they wind too much.
Why is this seemingly simple thing so important? Because the greater the angle between the nut (the top part of the guitar) and the tuning peg, the better the sustaining qualities of the string. Simply put, it makes you sound better. And your strings will not go out of tune as fast. Of course you can always wind too much as well, and then the strings will tend to slip out of tune easier. You want to have just the right amount.
Here is how to string your guitar.
Step 1 - Take all the strings out of the package and lay them out from the thickest to the thinnest. When you go to buy strings, always try and get the same gauge, as changing the gauge could mean problems with intonation, and may require truss rod adjustments.
Step 2 - Turn the tuning peg until the hole is in line with the neck.
Step 3 - Starting with the thickest string - The low "e", thread the string through the bridge (bottom part of the guitar). Each guitar has different ways to do this, but it is usually very easy to see where the strings go.
Step 4 - Next thread the string through the hole in the tuning peg until it is tight. Now back the string up about 3 inches so that it loosens.
Step 5 - Grab the loose part of the string with one hand and with the other start turning the tuning peg. As you turn the peg, hold the string tightly away from the guitar to insure that it wraps tightly, with no slack. This will stop the string from going out of tune as you're playing. When the string is getting tight against the fretboard, You can let go and continue to slowly turn the peg a little bit more and then top.
Step 6 - Make sure as you turn the peg that the string is winding downward, and don't let it flip over itself. Your goal is tog et about 2 1/2 to 3 full winds on each string.
Step 7 - Repeat the process with all other strings, but decrease the amount of slack a little bit each time.
All the best,
Tom Freeland
PlayGuitar.com
RSS feed
